Acura RSX, ILX and Honda EP3 Forum banner
1 - 1 of 1 Posts

· Registered
Joined
·
172 Posts
Don't know what you are doing wrong. Put the snap in the hole and then turn the screw. That draws in the rubber on the back and and creates an interference fit. I don't think you will feel the screw tighten up like a regular nut and bolt application. Before you try to install the mask test the snap by pulling on it to make sure it doesn't pop out.
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top