Acura RSX, ILX and Honda EP3 Forum banner

1 - 3 of 3 Posts

·
Registered
Joined
·
24 Posts
Discussion Starter #1
So i searched the threads and couldnt find any involving wing removal techniques. What Im specifically looking for is somebody who has done the job with good results that could share some knowledge. Id like to fill the holes and touch up paint if possible saving the costs of painting the whole lid/a body shop job. If I can find a replacement hatch lid at a decent price that is also another option. Thanks.

Ps. Can I go ahead and call my 05 DC5 an Integra or is that like somebody calling an R35 a Skyline?
 

·
Registered
Joined
·
53 Posts
You can try the plastic push fasteners . it'll be like a delete . so if you decide to convert back you have the option.
 

·
Registered
Joined
·
8 Posts
It seems like ideally you'd have a shop use a mig welder to patch the holes and then either you or they could sand it down flat. This is hard to do DIY because even if you have a mig welder if you're not experienced it's apparently quite easy to put too much heat into the panel and warp it, which can cause real problems.
192.168.100.1 192.168.1.1
 
1 - 3 of 3 Posts
Top