Acura RSX, ILX and Honda EP3 Forum banner

1 - 6 of 6 Posts

·
Registered
Joined
·
71 Posts
Discussion Starter #1 (Edited)
Tein Camber Plates

Barely used (in fact, only the Right plate was used, as we were troubleshooting a suspension issue).

Includes all original hardware and instructions, plus an 18mm--->14mm sleeve that will take up some of the space between the shaft of a Koni strut and the inside of the bearing. The top nut is 14x1.5mm thread pitch, and will fit Koni Yellows, Koni Race struts, as well as many of the Tein coilovers, and more. These are pretty low profile, and don't take up much suspension travel. Perfect for dialing in/out camber while maintaining a low ride height.

$160 shipped and paypal'd.



 
1 - 6 of 6 Posts
Top