Get 70mm pipe mandrel bent

 

how do i go about getting that done? Is there any way I could move my battery to the other side down inside my bumper some how? Or would I be better off doing what u said^?

 

You can relocate your battery pretty much wherever you want.

 

im trying to avoid doing so though. Any other ideas or input?

 

What intake do you have now, injen?

 

AEM Short ram. i was gonna buy an injen cold air but from what i hear, the coupler wont stretch over the 70mm throttle body =/

 

Ok so if you already have a short ram then just go to an exhaust shop and have them bend a 70mm pipe similar to your AEM. Where on the Island are you?

 

Huntington. They can do that?

 

You can have a shop mandrel bend a pipe however you want it. It's not hard to replicate a short ram intake. You also don't have to use the injen elbow. Try to source a similar coupler in the proper size.

 

My injen coupler went over my s2 70mm tb

I just chopped it in half n let it sit underthe battery tray

 

Theres a diy to 4 inch intake but he had torelocate

 

Op already said he doesn't want to relocate so the diy is pretty useless for him

 

If he flips the pipe i think it'll be like a short ram

 

buy AEM V2 intake the pipe is 3''